EN
DE
Analysis and Explanation of Auxiliary Component System
Below is the analysis and explanation of the auxiliary component system for your check and reference. If you have any other questions, please feel free to contact us!
Name |
Analysis and Explanation |
| guide block | Guide block between Plate A and Plate B |
| guide track | Positioning guide block/strip on sliding parts |
| guide rod | Guide rod |
| “T“ gib | Also known as T-bar |
| lever | Component used to push the ejector return rod first |
| early return pin | Swing lever in the reset mechanism, also known as swing lever |
| collide block | Component used to transfer force to the swing lever in the early reset mechanism |
| latch bar | / |
| latch lock | Used on the parting surface to control the parting sequence, also known as positioning latch |
| latch lock assembly | / |
| screw bushing | Commonly used in mold unscrewing mechanisms |
| copper bush | Mostly used for isolation between water channels and O-rings, with anti-rust function |
| gear | Transmission |
| rack | Transmission |
| chain | Transmission |
| link bar | / |
| link block | Connects two different components |
| support pin | Steel rod used for support in the ejector and support rod |
| wear plate | Also known as wear plate, a hardened component on sliding surfaces to reduce friction |
| p/l strap | Prevents the mold from separating during transportation |
| back-up plate | Support plate |
| cover plate | Usually installed between two side blocks to prevent dust or debris from entering the ejection system |
| height spacer | Mostly used when ejector pins or sleeves are too short, fixed on the ejector plate to increase height |
| lock | Component used to hook and pull the angled slider in the moving mold |
| lifting bar | Used for mold lifting, also known as lifting rod |
| mark plate | Metal plate engraved with basic information or images, fastened to the mold surface with φ3.3×6 rivets |
| cooling indicate plate | Nameplate engraved with a cooling channel diagram |
| counter view | Used for parting surface counting, also called parting surface counter |
| support pillar | Usually installed on the bottom clamp plate for support and mold rigidity improvement, also known as support pillar |
| stand off | Installed on the mold side for support, also known as a support post |
| support block | Installed on the A or B plate surface to increase the contact area between the upper and lower mold |
| calibration block | Used for product inspection |
| heat emiting pin | Used for heat conduction and dissipation, e.g., standard parts from Datong Company |
| gas pin | / |
| insert of gas pin | Component for installing air pins |
| magnet | / |
| stop pin | Installed on the back of the ejector plate to prevent dust from causing ejection system malfunction, also known as limit pin |
Get In Touch
Our senior sales and technical engineers will answer you questions fast and efficient.